Hi guys and girls,

We have had many backers asking if we could create a high quality pouch made from high spec materials to match the Splitter's quality, so we have begun doing some R & D and have started to design a pouch for the Splitter. Good things take time though, so we are really hoping to get the pouches design finished before the end of the kickstarter campaign, but aren't willing to scrimp on it's quality, so all we can only promise is that we will just try our best. 

I will send out further updates as we go along. Below is the pouch we previously made for our Muncher multi utensil, so this will be the jumping off point to start the design. Who knows where we will end up.



Be in touch again soon



October 11, 2018 — Mark Windsor